A Bent 80m OCFD

I visited a friend in OKC back in March of 2015 and took him a dual-core 4:1 Guanella balun I had built for his 80m OCFD project.  In addition to the balun, he also has a WIREMAN 8321 RF Choke inserted at the feedpoint.  The OM used my original OCFD design which I had made back in 2011.  

 

His yard was not large enough so he used a couple trees and two Spiderbeam fiberglass poles.

The antenna was erected in a 90 degree angle.

 

The SWR curve across 1 to 54 MHz (below) shows that it is good on 8 bands, despite being bent 90 degrees!  It covers ALL HF bands, plus 6m - EXCEPT for 160 and 17m.  

 

The light-yellow vertical columns represent the individual ham bands.

Aerial-51 Model 807A

How to create an adjustable bend point:

The picture below show you how to easily insert an insulator anywhere in the wire leg of the antenna without the need for removing the end-insulator.  After inserted, it can easily be adjusted at any time.

  1. Make a small loop in the wire at the point you wish to mount the insulator.
  2. Insert the loop through the top of the hole in one end of the insulator.
  3. Push it behind the insulator, far enough through the hole that it extends beyond the top of the insulator.
  4. Broaden the loop at the top such that it is wider than the insulator.
  5. Pull the loop towards you and over the front of the insulator, while also pulling the wire downwards.
  6. Pull it all the way down until it it tight.

 

When you are finished, you can adjust the position of the insulator easily by pushing both sides of the wire loop through the bottom hole and then tightening by pulling on just one side.